[Mar-2026] Dumps Practice Exam Questions Study Guide for the D-PSC-DY-23 Exam
D-PSC-DY-23 Dumps with Practice Exam Questions Answers
NEW QUESTION # 55
A customer has Smart Failed out a node named "node-1", and replaced it with another. The new node has identified itself as "node-8".
Which command(s) would allow the customer to change the identity of the new node to "node-1"?
- A. isi devices
- B. isi config
>>> lnnset - C. isi firmware update
- D. isi update
Answer: B
NEW QUESTION # 56
A customer has a 5-node cluster in which the SIP is answering DNS queries from node 1.
If node 1 goes down, to which node, or LNN, would the SSIP service move?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 57
An Isilon cluster has been configured with an autocommit period of 30 minutes for all compliance SmartLock directories. However, the storage administrator has noticed that files recently written to the folders can be deleted or modified.
Why is this happening?
- A. Offset time for autocommit has been met
- B. Compliance clock is out of sync with the autocommit function
- C. Manual commit must be used for all compliance SmartLock directories
- D. Offset time for autocommit has not been met
Answer: D
NEW QUESTION # 58
A storage administrator wants to check the current firmware status of an EMC Isilon cluster as quickly as possible.
Which command should you run to non-disruptively check this information?
- A. isi devices
- B. isi_for_array isi devices
- C. isi firmware status
- D. isi_for_array isi firmware status
Answer: C
NEW QUESTION # 59
What is the state of the source data when a failover to the target cluster has been completed?
- A. Retention rules are applied
- B. Read only
- C. Read/Write
- D. Files marked as locked by One FS
Answer: C
NEW QUESTION # 60
An Isilon cluster with three S210 nodes and three NL400 nodes was expanded to 18 nodes (15 x S210, 3 x NL400). You have been asked to revise the data protection policy initially set to N+3d:1n while optimizing the available writable disk space.
What is the recommended data protection strategy for each pool and will the data protection overhead average increase or decrease?
- A. S210 node pool remains N+3d:1n
NL400 node pool changes to N+2n - B. S210 node pool remains N+3d:1n
NL400 node pool changes to N+2d:1n - C. S210 node pool changes to N+2n
NL400 node pool remains N+3d:1n - D. S210 node pool changes to N+2d:1n
NL400 node pool changes to N+2d:1n
Answer: D
NEW QUESTION # 61
What is required to join an EMC Isilon cluster to an Active Directory domain?
- A. Domain account with rights to join domain
- B. Organizational Unit
- C. Reverse lookup zone
- D. Microsoft Management Console
Answer: A
NEW QUESTION # 62
Refer to the exhibit.
Which port is used to attach the node to the internal network?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 63
An administrator uses a TreeDelete job to delete a large directory. After the job starts, users notice an issue with performance on the cluster. Which recommended action will resolve the performance issue with the job?
- A. Let the job continue to run at the current impact level and schedule future jobs for after business hours so they do not impact users.
- B. Modify the running job to use a high impact policy to reduce the amount of time users are impacted.
Schedule the job after business hours in the future. - C. Modify the running job to use an OFF_HOURS policy that runs at low impact during business hours and medium impact after business hours.
- D. Pause the running job and resume after business hours using a high impact policy so that it does not impact users.
Answer: C
Explanation:
Isilon Administration and Management participant guide
NEW QUESTION # 64
You are using a Windows 2008r2 server and connecting to a share over SMBv2.
Where would the session or state information for the connection be maintained?
- A. Client-connected node and client
- B. Client-connected node only
- C. All nodes in the cluster
- D. Client only
Answer: B
NEW QUESTION # 65
A storage administrator has just configured a newly acquired Isilon cluster. The administrator connected to the console port of Node 1 and created subnets, pools, and two access zones called "Blue" and "Green".
The administrator then created shares in zone "Blue" and is able to access the shares from their Microsoft Windows clients. In addition, the administrator created exports in the "Green" zone and is able to access the exports from their UNIX clients.
However, the administrator is unable to SSH into the cluster and login as root.
What is a possible cause for this issue?
- A. A local user "root" needs to be created
- B. No interfaces exist in the System zone
- C. No authentication providers are defined in the "Blue" and "Green" access zones
- D. No failover address was configured for the InfiniBand network
Answer: B
NEW QUESTION # 66
What security settings are used to calculate effective permissions for Windows clients when accessing a Windows share?
- A. Windows group policy settings only
- B. Combination of share permissions only
- C. Combination of share permissions File or folder ACL
- D. Combination of local security policies File or folder ACL
Answer: C
NEW QUESTION # 67
A Dell PowerScale cluster has VHS enabled to deny writes lo the reserved disk space. The space allocation is configured with two settings
* At least three virtual drives
* At least 10% of the total storage space
What will be the reserved space allocation for VHS?
- A. Virtual drive space equivalent lo 3 drives
- B. The larger number of the two settings
- C. Combined space of 3 virtual drives and 10% storage space
- D. The smaller number of the two settings
Answer: B
NEW QUESTION # 68
Which operating system does NetWorker Virtual Edition use?
- A. Solaris
- B. Windows
- C. SLES
- D. RHEL
Answer: C
NEW QUESTION # 69
When configuring a cloud storage account on a Dell PowerScale cluster, what is entered in the 'Key' field?
- A. HTTPS and URI used to set up the cloud account
- B. License key to enable the CloudPools functionality
- C. User name that is provided to the cloud provider
- D. Account password provided by the cloud provider
Answer: C
NEW QUESTION # 70
An Isilon administrator wants to enable quota notifications for their LDAP users. However, the users' email IDs are not updated in the LDAP environment.
What additional configuration needs to be performed?
- A. Manage local users and groups
- B. Configured the file provider
- C. Configure a mapping rule
- D. Configure the local provider
Answer: C
NEW QUESTION # 71
What is the recommended maximum number of clusters and nodes that a single insightlCJ instance should simultaneously monitor?
- A. 6 clusters or 140 nodes
- B. 3 clusters or 60 nodes
- C. 5 clusters or 120 nodes
- D. 8 clusters or 150 nodes
Answer: D
NEW QUESTION # 72
Which cache type is used for read-ahead caching on behalf of other nodes?
- A. L3
- B. Endurant
- C. L2
- D. L1
Answer: C
NEW QUESTION # 73
An administrator requires SMB Continuous Availability (CA) on all existing SMB shares.
What needs to be done to meet this request?
- A. Run the global command from the web administration interface
- B. Nothing; SMB CA is on by default
- C. Log into the CLI to access the necessary command
- D. All shares must be reshared
Answer: D
NEW QUESTION # 74
A storage administrator used the shutdown -p <time> command to bring down an EMC Isilon cluster.
What could be the result of this action?
- A. Confirmation must first be acknowledged before actual shutdown
- B. The NVRAM will be flushed
- C. The filesystem could be left mounted when all nodes have shut down
- D. Data can become corrupted on the filesystem
Answer: D
NEW QUESTION # 75
When creating an SMB share on a Dell EMC Isilon cluster, what should the "Directory ACLs" setting be if adding a new share to an existing directory structure?
- A. Auto-Create Directories
- B. Do not change existing permissions
- C. Allow Variable Expansion
- D. Apply Windows Default ACLs
Answer: D
NEW QUESTION # 76
During a Dell PowerScale OneFS rolling upgrade, which protocols offer continuous availability functionality?
- A. SMB 2.0 and SMB 3.0
- B. SMB 2.0 and NFSv4
- C. NFSv4 and SMB 3.0
- D. NFSv3 and SMB 2.0
Answer: C
NEW QUESTION # 77
What must be done to configure cluster name resolution for SmartConnect?
- A. Create a host A record, add the DNS delegation, configure the subnet, and configure IPv4
- B. Create a host A record, create an NS record, configure the subnet, and configure the pool
- C. Create the SSIP, create an NS record, configure the subnet, and configure IPv6 and IPv4
- D. Create the SSIP, add the DNS delegation, configure the subnet, and configure the node pool
Answer: B
NEW QUESTION # 78
......
Free Dell Storage D-PSC-DY-23 Exam Question: https://www.examcost.com/D-PSC-DY-23-practice-exam.html
D-PSC-DY-23 by Dell Storage Actual Free Exam Practice Test: https://drive.google.com/open?id=1RGJ_BibINfvKPcfUtvmk6zEwNx3enBhf
